Rubber Pins

We want to inform you about the unique rubber pins Madern introduced for its rotary dies. 

Although the rubber pins are only tiny parts in our rotary dies, it offers big advantages for you.

The rubber pins enable proper release of potential sticky parts in the product area.

Placing these special rubber pins in the receiving holes prevents the accumulation of dust or waste.

The pins do not require the use of any glue, because they are self-tightening and based on friction.

In case of replacement of a rubber pin, the old one can be taken out and quickly replaced with a new one.

In addition, each size of rubber pins have a unique color, which increases visibility and enables clear distinction of the pin size.

The rubber pins have been successfully tested in practice as waste ejector pins and as filling for stripping pin receiving holes.

For insertion and removal of the pins we can supply a special tool.

Please refer to the article list below:

DESCRIPTION

COLOR

MADERN ARTICLE NR

Rubber ejector 1.2 mm

Red

MI-004513

Rubber ejector 1.7 mm

Green

MI-004514

Rubber ejector 2.0 mm

Blue

MI-004515

Rubber ejector 2.2 mm

Light grey

MI-004516

Rubber ejector 3.2 mm

Orange

MI-004517

Rubber ejector 4.2 mm

Yellow

MI-004518

Rubber ejector 5.2 mm

White

MI-004519

Rubber ejector 6.2 mm

Dark grey

MI-004520

DESCRIPTION

 

MADERN ARTICLE NR

Connector tools in leather case

 

MI-004536

DESCRIPTION

 

 

Removal set rubber ejector

 

 

Our recommendation is to order a set of spare ejectors, connectors and removal tools together with the reconditioning.

Each new tool will logically also be equipped with the new ejectors.